Balance is achieved in the human spine by three curves in the sagittal (side-view) plane. The normal cervical and lumbar spine is lordotic or concave posterior. The thoracic spine is convex posterior or kyphotic. The S-shaped configuration of the spine in the sagittal plane provides a shock-absorbing or spring like function which reduces stress on the vertebral column when weight loaded.

When the human spine is balanced in the sagittal plane, a plumb line dropped from the middle of the cervical spine should fall near the middle of the last lumbar segment. When any one of the curves increases or decreases out of proportion to the other two, the spine is thrown out of balance. The term flatback refers to a relative decrease in lumbar lordosis causing the spine and head to be decompensated forward. An individual with flat back will plumbline well anterior to the lumbar spine and pelvis.

Flat back syndrome refers to the constellation of symptoms experienced by an individual whose spine is forward decompensated through decreased lumbar lordosis. The most common clinical sign of this condition is a tendency to lean forward when walking or standing. Because it requires more energy to walk in a forward decompensated position, the body will tend to right itself.

Low back, buttock and posterior thigh muscles are recruited to tilt the pelvis in an attempt to bring the body into better alignment. These muscles will commonly fatigue, causing aching and pain. Hip and knee flexion while standing and walking, is another mechanism for aligning the spine in patients with loss of lumbar lordosis. When hip flexion is used chronically to stand erect, a hip flexion contracture can result as the muscles in front of the hip shorten. Interestingly enough, much of our awareness of flat back dates from our early experience with surgical instrumentation intended for the treatment of thoracolumbar scoliosis and degenerative spine disease. The Harrington rod and other similar devices produce correction of scoliotic lumbar deformities by utilizing distraction or lengthening forces in the concavity of the curve.

Although the curve is straightened in the front view plane, the same distraction forces applied to the concavity of the curve in the side view plane produce straightening of the lumbar lordosis and forward decompensation of the spine.

Although flat back syndrome was initially seen most commonly in patients with distraction-type instrumentation, loss of lumbar lordosis may occur in several other ways. During the aging process, for example, inter intervertebral disks lose water, degenerate and shrink; as the height of the spinal column shortens, lumbar lordosis may be lost. Compression fractures, most commonly caused by osteoporosis, can also flatten the curve of the lower spine and cause similar symptoms.

In many individuals, lack of lumbar lordosis does not produce symptoms. Those patients who are symptomatic however, can be treated. Most patients with symptomatic flat back should be treated initially with physical therapy. The emphasis of therapy should be on strengthening of the gluteal, low back, abdominal and hamstring musculature. Cardiovascular conditioning cannot be overemphasized as a method for improving pain tolerance.

Since symptoms are produced through abnormal mechanics of the spine, pelvis and upper legs, a brace intended to support a decompensated spine would have to cross each of these structures. Such braces are not usually effective. Similarly, trunk braces, which also capture the leg are not well tolerated by most individuals. In general, bracing is not an option for symptomatic flat back. When conservative methods fail and the patient is symptomatic to the point of being dysfunction due to the pain, surgery is indicated.

Flat back occurs most commonly in patients who have had previous spinal fusions. To recreate balance, it is necessary to break the fusion mass (osteotomy) and re-fuse the spine in a more balanced position. Particular techniques for osteotomy depend on the considerations such as the cause of the flat back, the presence of residual scoliosis and a patients’ general medical condition. While many osteotomies can be done through a posterior (back) approach only, other may require both a front and back surgery.

The surgical treatment of flat back is typically demanding. Many patient have long standing disability which renders them in less than optimum condition for surgery. Most patients have had previous surgery leaving them with soft tissue and, in many cases, nerve scarring. For these reasons, surgical complications occur more frequently in these patients than those undergoing surgery for the first time.

  1. Surgical treatment is normally less demanding in patients with small scoliotic curves, those with previous fusions for degenerative conditions or who have loss of lumbar lordosis due to inflammatory diseases such as ankylosing spondylitis.
  2. Since these patients need correction only in the sagittal plane, it is usually possible to operate through one exposure from the back. At our center, we have been successful with an adaptation of the decancellation procedure described by Thomasen.
  3. In this procedure, an osteotomy is performed below the Conus Medullaris or the lowest most extent of the spinal cord, usually at the L3 level. At the L3 level, there are only nerve roots in the spinal canal and because they are more pliable, surgery is less traumatic than it at higher levels where the spinal cord is less tolerant of movement and manipulation. In this procedure, the posterior bone at the L3 level is completely removed and the spongy contents of the vertebra is loosened and extracted. Pressure on the pelvis causes the spine to crack, closing the osteotomy and producing increased lumbar lordosis. Fixation devices, such as pedicle screws, rods and hooks are used to maintain correction. Bone graft is placed which ultimately heals producing a new fusion at the osteotomy site. We have been successful in producing 20-40 degrees of correction using this method.
This 52 year old male came to Dr. Pashman after five previous spine surgeries. He had a chronic, painful, stopped position. Dr. Pashman performed a posterior lumbar pedicle subtraction, closing osteotomy and instrumentated fusion from T10-L5. The patient’s symptoms were resolved.

In those patients who have scoliosis and flat back syndromes in the lumbar region, or any other deformity which produces decompensation left or right of the middle of the pelvis a three-dimensional correction is necessary to achieve spinal balance. Both anterior and posterior approaches are necessary in these patient. Discectomies or osteotomies in the front of the spine are performed at one or more levels, followed by standard osteotomies in the posterior spine. The instability that we can obtain by this type of circumferential surgery creates the opportunity to correct the spine both in the frontal and sagittal plane. A greater degree of correction can also be obtained from front and back surgery which may be necessary in any patient whose flat back requires more than 20-40 degrees of correction. Front and back surgery is also augmented with spinal fixation devices, the placement of bone graft and in many cases the application of a brace postoperatively. At our Center, most front and back surgeries are performed under one anesthesia (same day), enabling us to mobilize patients quickly during the postoperative period.

Many patient and their families ask “to what degree with the scoliotic curve be corrected by surgery?” However, the more important issue when contemplating scoliosis surgery is “will the progression of the curve be stopped and will spinal balance be achieved with surgery?” Spinal instrumentation is a powerful tool for the correction of spinal deformities, but it must be used with an appreciation for both frontal and sagittal plane alignment in the production of balance. Early use of these devices in the thoracolumbar spine considered only frontal plane deformity and in many individuals flat back was the result. Today, because of widespread attention to maintenance of lumbar lordosis by experienced spinal surgeons, the incidence of flat back is decreasing.

  1. Pashman RS, Lonstein JE, Bradford DS, et al: Moe’s Textbook of Scoliosis and Other Spinal Deformities 3rd Edition. Ankylosing Spondylitis W.B. Saunders Company, Philadelphia, Penn., 1994.
  2. Thomasen E: Vertebral osteotomy for correction of kyphosis in ankylosing spondylitis. Clin Orthop 194:142 – 152, 1985 April 9, 1996